剪紙玫瑰花的手工製作教程，太美了！
愛夢幻的女孩兒！
都會喜歡玫瑰花兒！
玫瑰雖美，卻也會凋謝！
今日小編就來教你們，
如何去摺紙一朵漂亮的玫瑰花！
A dreamy girl!
All like roses!
The rose is beautiful, but it will wither too.
The little editor is coming to teach you today.
How to fold a beautiful rose on the origami!
1
準備材料：
多種顏色皺紋紙、
雙面膠、剪刀、花桿、
綠色細裝飾紙帶（和雙面膠樣子大致相同）
綠色皺紋紙（做葉子用）
Preparation materials:
A variety of color wrinkled paper,
Double glue, scissors, flower,
A green fine decorative paper tape (roughly the same as a double-sided adhesive)
Green wrinkled paper (used for leaves)
步驟：
1. 將皺紋紙剪成20cm——25cm×40cm——45cm大小的長方形。如下圖
Step:
1. cut the wrinkle paper into 20cm - 25cm * 40cm - 45cm - sized rectangle. The following diagram
2．將每片皺紋紙照下圖的方法卷個邊
2. roll the edges of each piece of wrinkle paper
捲成下面圖中的樣子
Roll into the image below
3.然後反過來將紙片卷邊的下面用手指撕拉開來，形成半個鼓包的形狀。
3. then, in turn, tore the underneath with a finger, forming a half drum shape.
4.如下圖所示，在每片花瓣的下端貼上雙面膠。
4. as shown in the following figure, attach the double side glue to the lower end of each petal.
卷貼在綠色鐵絲花桿上，
Stick in the green wire rod,
第一片花瓣就粘好了。
The first petals are sticky。
以此類推，第二片花瓣和第一片花瓣錯開依次粘貼，
By this analogy, second petals and the first petals are pasting in turn,
每朵花六到八片花瓣就OK了，就做成下圖的樣子了。
Six to eight petals per flower are OK, and they look like the next figure.
5.在花瓣的下端用雙面膠粘上幾圈綠色細裝飾紙帶，做出花托的樣子。
In the end of 5. petals with double sided tape laps thin green decorative tape, make the receptacle.
最後，用綠色皺紋紙剪成花葉，共兩到三片，
Finally, cut the leaves with green paper, two to three.
錯開粘貼在花桿上，一朵玫瑰花就做成了。
Stagger the paste in a rose flower, made.
做好的成品還蠻好看的吧~
The finished product is pretty good.
2
材料：
三片樹葉，
一大片花萼，大約20片花瓣（5小15大），
綠膠布，
用紙包好的電線（共6根，三根主莖，三根葉子）
Material Science：
Three leaves,
A large calyx, about 20 petals (5 small, 15 large),
Green cloth,
A paper coated wire (6, three main stems, three leaves)
親愛的，你們學會了嗎？
拿起工具為您身邊的愛人折起來吧~
Do you learn, dear?
Pick up the tool and fold it for the lover around you.
TAG:剪紙迷 |